|Home||» Products||» Fluid Mechanics Lab Equipment||» CAVITATION APPARATUS|
Saini science industries manufacture of CAVITATION APPARATUS.
The apparatus has been designed to demonstrate the phenomenon of cavitation. The present set-up consists of a test section made of Acrylic having conversion and diversion section. Pressure tapings at appropriate position are provided. This test section is having one control valve at upstream side to regulate the water flow rate. Two pressure gauges are connected to these taping which give the pressure readout at the time of flow passing through this test section. The unit is self-contained close circuit type with sump tank, measuring tank and centrifugal pump. Flow through test section can be regulated with the help provided by-pass and control valve.
To observe the phenomenon of cavitation.
To compare the theoretical and actual pressures at cavitation condition.
Required for Operation:
Electricity supply: Single Phase, 220 V AC, 50 Hz, 5-15 amp combined socket with earth connection. Earth voltage should be less than 5 volts.
Water Supply (Initial Fill).
Floor Drain required.
Floor Area Required: 1.5 m x 0.75 m
Test Section : Material Acrylic
Pressure Gauge : 0-4 kg/cm2
Vacuum Gauge : 0-760 mmHg
Water Circulation : ½ HP Pump, Standard make.
Flow Measurement : Using Measuring Tank with Piezometer (Capacity 35 Ltrs.)
Sump Tank : Capacity 84 Ltrs.
Stop Watch : Electronic
Tanks will be made of Stainless Steel.
The whole set-up is ingeniously designed and schematically arranged on a powder-coated rigid structure
Standard make On/Off switch, Mains Indicator etc.
Scope of Delivery:
Self Contained “CAVITATION APPARATUS.” Apparatus
Instruction Manual consisting of experimental procedures, block diagram etc.